Nissan X-Trail Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Have a x-trail 2004 2,2 dci 136hp.
engine cuts of when comes down to1000 rpm. engine runs perfecly nice , but this..
have replaced timiing chains , and same. have replaced crank and cam censors. checked rail pressure, over 500 bar when cuts of.
engine get more difficult to start when warm, cold no problem. no fault codes...
any ideas????
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Don't know, but reading out a good pressure before it cuts...About 400 bar.
And when I try to start... about 500 bar..
Should be more than enough says the Nissan workshop...
The weard thing is that when I unplug the camshaft sensor it have no problem to start and run on idle....
Tryed to replace it, but no change
 
1 - 3 of 3 Posts
Top